Welcome guest, please Login or Register
forgot password?

Forum

Elevation Tools in the Z-direction

18 February 2016 01:22 pm

Ellyn P. [34188]

  • Newbie
  • *
  • Total Posts: 1
In Navisworks, there is a coordinate system that can be pulled up into the window that can be used to move the X-Y plane in the Z direction essentially "cutting" up or down in the Z-direction.

Is there a way to cut the model this way in Revizto Viewer?

I am trying to move down from seeing one floor plate as a whole, to the floor below as a whole.

Thank you
 
19 February 2016 08:25 am

Alexey Zuev

  • Administrator
  • *****
  • Total Posts: 232
Sorry, I didn't understand the question. Can you explain this with a couple of screenshots?